Chainsaw Sharpening Tricks

3

The progress from the hatchet to the chainsaw may very well be the best transformative jump throughout the entire existence of tools. Consider the big picture. The task of felling a tree went from tedious and terribly ruthless, to incredibly speedy and easy.

Today, chainsaws are regularly used by professional arborists to chop down and cut up trees. Even the biggest, most remarkable chainsaw will not cut with a dull saw chain. Fortunately, dissimilar to most other power-cutting tools, you can sharpen a chainsaw to like-new condition in only a couple of minutes.

Secure the Saw:

Before you can start sharpening your chainsaw you should fasten the saw just as the chain to make it simpler to hold the saw and chain set up while you sharpen it. Out in the field, this will mean tracking down a level where your saw can sit without wobbling, as on the back end of a pickup or top of an enormous tree stump. In the shop, the least demanding thing is to daintily clip the shaper bar in a bad manner.

back to menu ↑

Secure the Chain:

You will sharpen joins around the chain, which implies it will be quite hard to tell when you have sharpened all the cutters on the chain. Since they all carbon copies, you will need to check the main shaper so you will know when you arrive at the end. A touch of fine paint on the level surface of the shaper will get the job done.

back to menu ↑

Follow the Proper Angle:

The guide rollers will hold you back from diving excessively deep with your file, however, you should focus on the point of the top plate on the shaper to keep a reliable point and appropriately sharpen the saw. If you are not steady with your cutting points, your saw won’t cut easily and the chain will in general tie or pull. Furthermore, a chain with ill-advised points will make more residue, which will gum up the engine and chain.

back to menu ↑

Smooth and Even Strokes:

Use your file to cut consistent, even strokes. An all-around kept-up chain won’t require several strokes on every shaper to keep the edge sharpened. You will need to drive the file from you to clear metal chips and garbage away from the edge as opposed to drawing them onto it. To make a reliable front line on all connections make certain to use a similar number of strokes on every shaper. Don’t re-sharpen cutters you have effectively sharpened.

back to menu ↑

Turn the Chain:

Subsequent to sharpening a few cutters, release the brake to allow the chain to be progressed. Push the chain ahead so that dull cutters are in a similar area to the ones you just sharpened, and afterward reset the brake. Pushing the chain ahead as opposed to trying to work around the chain from different positions will make things much more pleasant and significantly more expected.

Spread the love

We will be happy to hear your thoughts

Leave a reply

Chainsaw Care
Logo
Enable registration in settings - general